Zach "earboxer" DeCook @zachdecook@librem.one

@jameschip is there supposed to be punctuation in that sentence?

@jameschip I created this chart from a world record progression page in wikipedia for a #swimming category. Over 100 years in this category, the fastest men's swimmer at a given time has always been faster than the fastest women's swimmer at that same time. #gendersports
https://en.m.wikipedia.org/wiki/World_record_progression_400_metres_freestyle

@linuxlounge Do you happen to use vi? I switched to #dvorak back before I discovered the editor wars (I was using gedit), and now I use #micro, but vi keybindings are so common across tui apps, it's a little frustrating .

@thatonecalculator @PINE64 ooh, jealous! I ordered just before CNY, so hopefully I'll get mine in due time.

@hamblingreen Yeah, even easier than setting up a web server: install and configure gmnisrv, then forward the port on your router to the pinephone's IP address.
(Of course, this means the capsule will be offline when you take the phone anywhere, or turn it off).

@hamblingreen Have you ever heard of gemini (protocol)?

@danct12 @PINE64 is the mouse usable given the screen refresh rate?

@flabbonix @purism @scops I can't wait to get my #Librem5 because on all my other "mobile" devices, "screen too big".

@kop316 afaik, iPhone apps can't sent/receive sms. That is why silence.im doesn't have an iPhone app.

@mart GPLv3 code?

@PINE64 Other (I think ordinary) wear and tear from infrequent opening would be the clip closest to the dip switches starting to wear both frame-side and back plate side. So maybe a third thumbnail slot in that corner as well... at that point might as well put one in each corner.

Anyone else crack their #pinephone back plate like this?
Maybe this is from dropping it and/or opening it too much.
I think the design could be fixed if @PINE64 made a backplate that had thumbnail slots on both sides.

@linuxlounge @linuxlounge @LinuxLounge (man putting comments in the right place is difficult. Why do you have 3 fediverse accounts? It'd probably be easier if you dropped one of the peertube accounts and boosted the peertube post from mastodon instead of making a new post).

@FredBednarski @neauoire @rek maybe texture could be used instead of black/white so each die could be printed as a single piece (think stripes/solids in pool, but textured).
Since one side is completely white, that could be the untextured side that sits on the build plate.

@linuxlounge did you manage to test performance with framebufferphone or sxmo?

https://www.jwz.org/doc/cadt.html

The CADT model of software design: just rewrite it!
Note that I do encourage (on the consumer's part) fixing bugs over reporting them, but I covet stability from maintainers.