The second attempt is looking good for this 3D printed case for my knitting clock. Along with fixing some mistakes in my design, I also modified it so that it could print for the most part without supports. There was one area where that was unavoidable, so I added in basic supports. While there is a little cleanup where it bridged there, it's much less than I saw when I enabled internal supports in the first print.

Sign in to participate in the conversation
Librem Social

Librem Social is an opt-in public network. Messages are shared under Creative Commons BY-SA 4.0 license terms. Policy.

Stay safe. Please abide by our code of conduct.

(Source code)

image/svg+xml Librem Chat image/svg+xml