#3Dmodeling #PartDesign #FreeCAD community, I could use your help!
I have these two speakers, which came in their own plastic housing. I want to use them as part of a bigger device, in a 3D-printed enclosure. However, I cannot figure out how best to secure them in place.
As you can see, at each corner of the speaker, there is what looks like a mounting hole, so I was initially thinking of driving screws through two of them into either a threaded receptacle or a captive nut. However, there is very little horizontal space (my calipers say less than 0.5mm) surrounding the hole, where the flat of a screw head might gain purchase, so I don't think this is a viable option.
What other ideas do you have for securing these speakers in place inside a 3D-printed enclosure?
I have these two speakers, which came in their own plastic housing. I want to use them as part of a bigger device, in a 3D-printed enclosure. However, I cannot figure out how best to secure them in place.
As you can see, at each corner of the speaker, there is what looks like a mounting hole, so I was initially thinking of driving screws through two of them into either a threaded receptacle or a captive nut. However, there is very little horizontal space (my calipers say less than 0.5mm) surrounding the hole, where the flat of a screw head might gain purchase, so I don't think this is a viable option.
What other ideas do you have for securing these speakers in place inside a 3D-printed enclosure?
